BRAKE PEDAL STROKE SENSOR REMOVAL

Note

While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing the brake system components, do not depress the brake pedal or open/close the doors while the battery is connected.


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

  2. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  3. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Tech Tips

    Refer to the procedure from Remove Driver Side Knee Airbag Assembly Click here.

  4. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY (for LHD)


    1. A01NHCLE01

      Disconnect the sensor connector.

    2. A01NCQ1E04

      Remove the 2 bolts and brake pedal stroke sensor.

      Note

      Do not drop the sensor. If the sensor has been dropped, replace the brake pedal stroke sensor with a new one.

  5. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY (for RHD)


    1. A01NDNNE01

      Disconnect the sensor connector.

    2. A01NF0RE01

      Remove the 2 bolts and brake pedal stroke sensor.

      Note

      Do not drop the sensor. If the sensor has been dropped, replace the brake pedal stroke sensor with a new one.