FRONT SPEED SENSOR INSTALLATION

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace it together with the front drive shaft assembly.


  1. INSTALL FRONT SPEED SENSOR


    1. A01NFWKE01
      Text in Illustration
      *1 Resin Clamp

      Install the resin clamp and front speed sensor with the bolt.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Note


      • Prevent foreign matter from attaching to the front speed sensor tip.

      • Firmly insert the front speed sensor body into the knuckle before tightening the bolt.

      • After installing the front speed sensor to the knuckle, make sure that there is no clearance between the front speed sensor stay and knuckle. Also make sure that no foreign matter is stuck between the parts.

      • Before installing the clamp, firmly insert the points of the clamp into the installation holes.

    2. A01NHJ8E01
      Text in Illustration
      *1 Stopper Hole
      *2 No. 1 Sensor Clamp

      Temporarily install the No. 1 sensor clamp.

      Note

      Be sure to insert the No. 1 sensor clamp into the stopper hole while installing the No. 1 sensor clamp.

    3. A01NFA4E01
      Text in Illustration
      *1 No. 1 Sensor Clamp
      *2 Front Brake Flexible Hose

      Install the front brake flexible hose and No. 1 sensor clamp together to the shock absorber with the bolt.

      Torque:
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }

      Note


      • Do not twist the wire harness for the front speed sensor when installing it.

      • The bolt tightens the brake flexible hose and front speed sensor together. Make sure that the flexible hose is positioned over the front speed sensor.

    4. A01NHZCE03
      Text in Illustration
      *1 No. 2 Sensor Clamp

      Install the No. 2 sensor clamp to the body with the bolt.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
    5. A01NEEW

      Install the 2 clamps and connect the front speed sensor connector.

    6. A01NI0T

      Install the front fender liner with the 5 clips and 3 screws.

    7. A01NHDTE01
      Text in Illustration
      *1 Correct
      *2 Incorrect

      Install the 2 pin hold clips.

      Note

      Insert the pin hold clips with the slots aligned vertically. Do not rotate the clips after inserting them. After installation, confirm that the slots are vertical.

      Tech Tips

      Use the same procedure for the RH side and LH side.

  2. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL REAR DECK FLOOR BOX


    1. A01NDSY

      Install the rear deck floor box with the 3 clips.

  5. CHECK FOR SPEED SENSOR SIGNAL

    Tech Tips

    Click here.