AUDIO AND VISUAL SYSTEM (w/ Navigation System) Illumination Circuit

DESCRIPTION

Power is supplied to the radio receiver assembly illumination when the light control switch is in the tail or head position.

WIRING DIAGRAM

A01NFLXE01

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK ILLUMINATION


    1. Check if the illumination for the radio receiver assembly, heater control switch or others (hazard switch, transmission control switch, etc.) comes on when the light control switch is turned to the head or tail position.

      Result
      Result Proceed to
      Illumination comes on for all components except radio receiver assembly. A
      No illumination comes on (radio receiver assembly, hazard switch, heater control switch, etc.). B

    B
    A
  2. CHECK HARNESS AND CONNECTOR (BATTERY - RADIO RECEIVER ASSEMBLY)


    1. A01NCWRE12
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Radio Receiver Assembly)

      Disconnect the radio receiver assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      G12-3 (ILL+) - Body ground Light control switch tail or head 11 to 14 V

    NG
    OK
  3. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY)


    1. A01NE80E01
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Radio Receiver Assembly)

      *2

      Front view of wire harness connector

      (to Combination Meter Assembly)

      Disconnect the radio receiver assembly connector and combination meter assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G12-17 (ILL-) - F15-15 (ILL-) Always Below 1 Ω
      F15-16 (E2) - Body ground Always Below 1 Ω
      F15-15 (ILL-) - Body ground Always 10 kΩ or higher

    NG
    OK