ДАТЧИК ПОЛОЖЕНИЯ ПАРКИНГА / НЕЙТРАЛИ УСТАНОВКА


  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A0118OP

      Temporarily install the park/neutral position switch with the 2 bolts.

    2. A01193P

      Install the nut and a new nut stopper.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }
    3. A011BYE

      Temporarily install the transmission control shaft lever, rotate it counterclockwise until it stops, rotate it clockwise for 2 notches to the N position, and then remove the transmission control shaft lever.

    4. A011ADPE01
      Text in Illustration
      *1 Nut Stopper Protrusion
      *2 Neutral Reference Line

      Align the neutral reference line with the protrusion on the nut stopper and fully tighten the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    5. A0119SJ

      Bend the tabs of the nut stopper with a screwdriver.

    6. A011B89

      Install the transmission control shaft lever and spring washer, and tighten the nut.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }
    7. A0119OC

      Connect the park/neutral position switch connector.

  2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A011AKJ

      Using the nut, connect the transmission control cable to the transmission control shaft lever.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

      Note

      Confirm that the shift lever is in the N position.

  3. INSPECT SHIFT LEVER POSITION


    1. Включите зажигание и нажмите на педаль тормоза.

    2. Убедитесь, что рычаг переключения передач плавно перемещается через все положения, а индикатор положения показывает правильное положение рычага переключения передач.

    3. Запустите двигатель и убедитесь, что автомобиль движется вперед, когда рычаг переключения передач перемещается из положения N в положение D.

  4. ADJUST SHIFT LEVER POSITION


    1. Remove the console panel upper Click here.

    2. Move the shift lever to N.

    3. A011ALNE01
      Text in Illustration
      *1 Adjuster Case
      *2 Cover

      Slide the adjuster case cover in the direction shown by the arrow.

    4. Using a precision screwdriver, pull up the lock piece.

      Text in Illustration
      *3 Lock Piece
    5. A0117N3E01
      Text in Illustration
      *1 Adjuster Case
      *2 Lock Piece
      *3 Cable Rod

      Press the lock piece into the adjuster case.

      Tech Tips

      Lightly pull the cable rod towards the back of the vehicle to eliminate slack, and then lock the adjuster.

    6. Slide the adjuster case cover in the direction shown by the arrow.

      Text in Illustration
      *1 Adjuster Case
      *4 Cover

      Note

      If the cover is not pushed over the protrusion on the lock, the cable will not lock and shift operation will not be accurate.

    7. Install the console panel upper Click here.