ДАТЧИК ОБОРОТОВ (NOUT) ПРОВЕРКА


  1. INSPECT TRANSMISSION REVOLUTION SENSOR (NOUT SENSOR)


    1. Connect the battery into the transmission revolution sensor (NOUT).

      A0117JOE06
      Text in Illustration
      *1

      Component without harness connected

      (Transmission Revolution Sensor NOUT)

      		 *3 5 mm Gap or Closer
      *2 Ammeter *4 Magnetic Object

    2. Wave a magnetic object left and right in front of the transmission revolution sensor tip (5 mm gap or closer) to change the high/low signals while measuring the current.

      Note

      Make sure to wave the magnetic object during the inspection. Current will not change without waving the magnetic object as indicated by the arrow in the illustration.

    3. Measure the current according to the value(s) in the table below.

      Standard Current
      Tester Connection Condition Specified Condition
      1 (NOTO) - 2 (NOTB) Low Signal 4 to 8 mA
      High Signal 12 to 16 mA

      If the current value is not as specified, replace the transmission revolution sensor (NOUT).