СТАРТЕР (для моделей мощностью 2,0 кВт) РАЗБОРКА


  1. REMOVE STARTER TERMINAL


    1. A0119Q5

      Open the terminal cap.

    2. Remove the nut and the starter terminal.

  2. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    1. A0119I4

      Remove the nut and disconnect the lead wire from the magnet starter switch assembly.

    2. A01194R

      Remove the 2 nuts that hold the starter magnet switch assembly to the starter housing.

    3. A0118AGE02
      Text in Illustration
      *1 Plunger Hook
      *2 Starter Pinion Drive Lever

      Pull the magnet starter switch assembly while lifting the front part of the magnet starter switch assembly, release the plunger hook from the starter pinion drive lever, and remove the magnet starter switch assembly.

  3. REMOVE STARTER DRIVE HOUSING ASSEMBLY


    1. A011845

      Using long "TORX" socket wrench T30, remove the 2 through bolts.

    2. A011775

      Pull out the starter yoke and the starter commutator end frame together with the armature.

    3. A0118PC

      Remove the starter pinion drive lever.

  4. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY


    1. A0117DS

      Remove the 2 screws and starter commutator end frame.

      Note

      While holding down the lead wire, remove the starter commutator end frame.

  5. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    1. A01174O

      Using a screwdriver, hold the spring back and disconnect the brush from the brush holder.

    2. Disconnect the 4 brushes, and remove the brush holder.

  6. REMOVE STARTER ARMATURE ASSEMBLY


    1. A0119T4

      Remove the starter armature from the starter yoke.

  7. REMOVE STARTER YOKE ASSEMBLY


    1. A0119P3

      Remove the starter yoke from the starter center bearing clutch.

  8. REMOVE STARTER ARMATURE PLATE


    1. A0116YAE01

      Remove the starter armature plate from the starter center bearing clutch.

  9. REMOVE STARTER PLANETARY GEAR


    1. A011BFY

      Remove the 3 planetary gears from the starter center bearing clutch.