МАСЛЯНЫЙ НАСОС УСТАНОВКА


  1. INSTALL OIL PUMP DRIVE AND DRIVEN ROTORS


    1. Apply engine oil to the drive and driven rotors.

    2. Apply engine oil to the shafts on the oil pump drive rotor.

    3. A011BOGE01
      Text in Illustration
      *1 Alignment Mark

      Align the oil pump drive rotor mark with the driven rotor mark.

    4. Install the oil pump drive rotor with the driven rotor to the oil pan.

  2. INSTALL OIL PUMP ASSEMBLY

    A0119SX

    1. Install the oil pump with the 4 bolts.

      Torque:
      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }

  3. INSTALL NO. 2 CHAIN SUB-ASSEMBLY

    A011A0IE02
    Text in Illustration
    *1 TDC Mark
    *2 Key
    *3 Oil Pump Shaft
    *4 Flat Faces

    1. Align the crankshaft key with the TDC mark on the cylinder block.

    2. Rotate the oil pump shaft so that the flat faces left when viewing the cylinder block from the front.

    3. A0118TBE02
      Text in Illustration
      *1 Timing Mark
      *2 Mark Link
      *3 Oil Pump Drive Gear
      *4 Oil Pump Drive Shaft Gear

      Align the orange mark links with the timing marks of each gear as shown in the illustration.

    4. A011BRS

      Install the sprockets onto the crankshaft and oil pump shaft with the chain wrapped on the gears.

    5. A011AVI

      Insert a 4 mm (0.157 in.) diameter bar into the adjusting hole on the oil pump drive shaft gear to lock the gear in position, and then tighten the nut.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }
    6. A011AGRE02
      Text in Illustration
      *1 Tensioner Plate
      *2 Damper Spring
      *3 Pin
      *4 Pivot Hole

      Install the chain tensioner plate with the chain damper spring to the pin.

      Note


      • Push the chain tensioner plate so that the area around the pivot hole reaches the base of the pin.

      • The end of the spring should contact the side of the oil pan so that tension is applied to the chain.

    7. A01198LE02
      Text in Illustration
      *1 Timing Mark
      *2 Mark Link
      *3 TDC Mark
      *4 Key

      Check that the mark plate and timing mark are in the positions shown in the illustration.

  4. INSTALL CHAIN SUB-ASSEMBLY


    1. Install the chain sub-assembly Click here.