НАГНЕТАЮЩИЙ ТОПЛИВНЫЙ НАСОС СНЯТИЕ


  1. REMOVE EGR WITH COOLER PIPE ASSEMBLY


    1. Remove the EGR with cooler pipe assembly Click here.

  2. REMOVE NO. 1 EGR COOLER BRACKET


    1. A0117LI

      Disconnect the vacuum hose.

    2. Remove the 2 bolts and No. 1 EGR cooler bracket.

  3. REMOVE NO. 2 INJECTION PIPE CLAMP


    1. A0118OJ

      Remove the nut and both sides of the No. 2 injection pipe clamp.

  4. REMOVE FUEL INLET PIPE SUB-ASSEMBLY


    1. A0117G5

      Using a wrench (17 mm), hold the supply pump nut, and using a union nut wrench (17 mm), separate the union nut from the supply pump first.

    2. Then remove the union nut from the common rail, and remove the fuel inlet pipe.

    3. After removing the fuel inlet pipe, cover the common rail with vinyl tape and cover the injector inlet with a vinyl or plastic bag in order to prevent dust and foreign matter from entering.

  5. REMOVE SUPPLY PUMP ASSEMBLY


    1. A0119K5

      Disconnect the 2 fuel hoses.

    2. Disconnect the 2 connectors.

    3. Remove the bolt and separate the harness bracket.

    4. A01188P

      Remove the retainer spring and separate the nozzle leakage pipe.

    5. Disconnect the No. 2 fuel hose.

    6. A011BQR

      Remove the 3 bolts and supply pump.

    7. A0118J9

      Remove the O-ring.

  6. REMOVE SUPPLY PUMP DRIVE COUPLING


    1. A0119VH

      Remove the supply pump driving coupling.

      Note

      When removing the supply pump, make sure that the drive coupling does not fall off, as it can be easily removed. If the drive coupling falls off, replace it with a new one.