ЗАДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА СНЯТИЕ


  1. REMOVE NO. 1 CRANKSHAFT POSITION SENSOR PLATE


    1. Remove the No. 1 crankshaft position sensor plate Click here.

  2. REMOVE ENGINE REAR OIL SEAL


    1. Using a knife, cut off the oil seal lip.

    2. A0118UBE02
      Text in Illustration
      *1 Cut Position

      Using a screwdriver with its tip wrapped in protective tape, remove the engine rear oil seal.

      Note

      After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.