ПЕРЕДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА СНЯТИЕ


  1. REMOVE FRONT WHEEL RH

  2. REMOVE NO. 3 ENGINE UNDER COVER

    A01181U

    1. Снимите 3 фиксатора и защиту картера двигателя № 3.

  3. REMOVE NO. 1 COOLER COVER (w/ No. 1 Cooler Cover)

    A0119EA

    1. Remove the 2 nuts and the No. 1 cooler cover.

  4. REMOVE NO. 4 ENGINE COVER (w/ No. 4 Engine Cover)

    A0117VM

    1. Remove the 2 bolts, nut and the No. 4 engine cover.

  5. REMOVE NO. 1 V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT (w/ Air Conditioning System)

    A0119GZE01

    1. Loosen bolts A and B.

    2. Remove the No. 1 V belt.

  6. REMOVE FAN AND GENERATOR V BELT

    A011A8N

    1. Release the V belt tension by turning the V-ribbed belt tensioner counterclockwise, and remove the V belt from the V-ribbed belt tensioner.

    2. While turning the V-ribbed belt tensioner counterclockwise, align the holes, and then insert a 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner.

  7. REMOVE CRANKSHAFT DAMPER SUB-ASSEMBLY

    A011AGCE01

    1. Using SST, hold the crankshaft damper and loosen the crankshaft bolt.

      SST
      09213-58014
      09330-00021
    2. A0118JGE01

      Using SST, remove the crankshaft pulley bolt and the crankshaft pulley.

      SST
      09950-30012   ( 09951-03010, 09953-03010, 09956-03020 )

  8. REMOVE TIMING CHAIN COVER OIL SEAL


    1. Using a knife, cut off the oil seal lip.

    2. A0118OEE02
      Text in Illustration
      *1 Cut Position
      *2 Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, remove the oil seal.

      Note

      After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.