ПРИВОДНОЙ РЕМЕНЬ ПРОВЕРКА


  1. REMOVE NO. 3 ENGINE UNDER COVER

    A0118DM

    1. Снимите 3 фиксатора и защиту картера двигателя № 3.

  2. REMOVE NO. 1 COOLER COVER (w/ No. 1 Cooler Cover)

    A0117FV

    1. Remove the 2 nuts and the No. 1 cooler cover.

  3. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    A0118W1

    1. Remove the 2 bolts, nut and the No. 1 engine cover.

  4. INSPECT FAN AND GENERATOR V BELT

    A011BNY

    1. Visually check the belt for excessive wear, frayed cords etc.

      If any defect is found, replace the belt.

      Tech Tips

      If the belt has pieces missing from the ribs, it should be replaced.

  5. INSPECT NO. 1 V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT

    A011BNY

    1. Visually check the belt for excessive wear, frayed cords etc.

      Tech Tips

      If the belt has pieces missing from the ribs, it should be replaced.

  6. INSTALL NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    A0118W1E01

    1. Temporarily install the No. 1 engine cover with the 2 bolts and nut.

    2. Fully tighten the 2 bolts and nut in the order shown in the illustration.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  7. INSTALL NO. 1 COOLER COVER (w/ No. 1 Cooler Cover)

    A0117FVE01

    1. Temporarily install the No. 1 cooler cover with the 2 nuts.

    2. Fully tighten the 2 nuts in the order shown in the illustration.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

  8. INSTALL ENGINE UNDER COVER NO.3

    A0118DM

    1. Install the No. 3 engine under cover with the 3 clips.