ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА УСТАНОВКА


  1. INSTALL CRANK POSITION SENSOR


    1. A011ATJ

      Apply a small amount of engine oil to the O-ring.

    2. Install the crank position sensor with the bolt.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

      Note

      Install the O-ring to the oil pump and make sure that the O-ring is not cut or pinched.

    3. Connect the crank position sensor connector.

  2. INSTALL NO. 3 ENGINE UNDER COVER

    A0118DM

    1. Install the No. 3 engine under cover with the 3 clips.