FRONT BLOWER MOTOR REMOVAL


  1. REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)

    Tech Tips

    Use the same procedure as for the RH side Click here.

  2. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH (for LHD)

    Tech Tips

    Use the same procedure as for the RH side Click here.

  3. REMOVE COWL SIDE TRIM BOARD LH (for LHD)

    Tech Tips

    Use the same procedure as for the RH side Click here.

  4. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL (for LHD)

    A011AI9

    1. Remove the 2 <C> bolts.

    2. Disengage the 2 claws and the 7 clips and separate the lower No. 1 instrument panel finish panel.

    3. A011AQB

      Disconnect the connector.

    4. Disengage the 2 claws and disconnect the DLC3 connector.

    5. A0118KA

      Disengage the 3 claws and disconnect the hood lock control lever.

  5. REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY


    1. A011AN2

      Disconnect the connector.

      Tech Tips

      If the vehicle is equipped with stop and start system, disconnect the connector.

    2. A0119AW

      Remove the clip.

    3. Disengage the 3 claws and remove the air duct.

  6. REMOVE CLUTCH PEDAL SUB-ASSEMBLY (for RHD Manual Transaxle)


    1. Remove the clutch pedal sub-assembly Click here.

  7. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY

    A011BS9E01
    Text in Illustration
    *1 Protective tape

    1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the air duct.

  8. REMOVE BLOWER W/FAN MOTOR SUB-ASSEMBLY

    A0118MC

    1. Disconnect the connector.

    2. Remove the 3 screws and remove the blower w/fan motor.