COMPRESSOR (for 1ND-TV) DISASSEMBLY


  1. REMOVE MAGNET CLUTCH ASSEMBLY

    A011BLXE01

    1. Clamp the cooler compressor in a vise.

    2. Using SST, hold the magnet clutch hub.

      SST
      09985-00040

    3. Remove the bolt, magnet clutch hub and magnet clutch washer(s).

      Tech Tips

      There is no set number of magnet clutch washers since they are used for adjusting.

    4. A011BL8

      Using a snap ring expander, remove the snap ring and the magnet clutch rotor.

      Note

      Do not damage the seal cover of the bearing when removing the snap ring.

    5. Remove the screw and disconnect the ground wire.

    6. Disconnect the connector.

    7. A0119JJ

      Using a snap ring expander, remove the snap ring and magnet clutch stator.