FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side) INSTALLATION

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.


  1. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH


    1. A0117VN

      Install the front seat inner belt with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    2. Engage the wiring harness clamp.

    3. A0119YF

      Engage the wiring harness clamp.

    4. Install the buckle switch connector.

  2. INSTALL FRONT SEAT CUSHION INNER SHIELD RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  3. INSTALL FRONT SEAT ASSEMBLY RH

    A011AHWE01

    Note

    Follow the procedure described below in order to prevent the seat tracks from locking separately.


    1. Insert the 2 location pins through the 2 body holes, place the front seat in the most forward position and make sure that the inner and outer seat tracks are locked securely.

    2. Using "TORX" socket wrench E10, install bolt 1 and then bolt 2 onto the rear side.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    3. Move the front seat to the most rearward position, and then make sure that the inner and outer seat tracks are securely locked.

    4. Using "TORX" socket wrench E10, install bolt 3 and then bolt 4 onto the rear side.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    5. Make sure that the inner and outer seat tracks lock simultaneously after the seat is moved.

      Tech Tips

      If the inner and outer seat tracks do not lock simultaneously, loosen the bolts and adjust the seat tracks.

    6. A01170K

      for LHD front passenger seat:


      1. Connect the front seat side airbag connector.

      2. Connect the front seat cushion airbag connector.

      3. Connect the buckle switch connector.

      4. Connect the front seat wire connector.

      5. Install the wiring harness clamp.

    7. A0119ZF

      for RHD front passenger seat:


      1. Connect the front seat side airbag connector.

      2. Connect the front seat cushion airbag connector.

      3. Connect the buckle switch connector.

      4. Connect the front seat wire connector.

      5. Install the wiring harness clamp.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  5. INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light Click here.