FRONT SEAT ASSEMBLY INSTALLATION

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

Note

Always use "TORX" socket wrench E10 when installing the front seat.

Tech Tips

The procedure described below is for the driver side LHD. Use the same procedure for both the front passenger and driver sides of LHD, unless otherwise specified.


  1. INSTALL FRONT SEAT ASSEMBLY LH

    A011BI1E01

    Note

    Follow the procedure described below in order to prevent the seat tracks from locking separately.


    1. Insert the 2 location pins through the 2 body holes, place the front seat in the most forward position and make sure that the inner and outer seat tracks are locked securely.

    2. Using "TORX" socket wrench E10, install bolt 1 and then bolt 2 onto the rear side.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    3. Move the front seat to the most rearward position, and then make sure that the inner and outer seat tracks are securely locked.

    4. Using "TORX" socket wrench E10, install bolt 3 and then bolt 4 onto the rear side.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    5. Make sure that the inner and outer seat tracks lock simultaneously after the seat is moved.

      Tech Tips

      If the inner and outer seat tracks do not lock simultaneously, loosen the bolts and adjust the seat tracks.

    6. A01190A

      Connect the airbag connector.

    7. Connect the buckle switch connector.

    8. Install the wiring harness clamps.

  2. INSTALL FRONT SEAT ASSEMBLY RH

    A011AHWE01

    Note

    Follow the procedure described below in order to prevent the seat tracks from locking separately.


    1. Insert the 2 location pins through the 2 body holes, place the front seat in the most forward position and make sure that the inner and outer seat tracks are locked securely.

    2. Using "TORX" socket wrench E10, install bolt 1 and then bolt 2 onto the rear side.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    3. Move the front seat to the most rearward position, and then make sure that the inner and outer seat tracks are securely locked.

    4. Using "TORX" socket wrench E10, install bolt 3 and then bolt 4 onto the rear side.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    5. Make sure that the inner and outer seat tracks lock simultaneously after the seat is moved.

      Tech Tips

      If the inner and outer seat tracks do not lock simultaneously, loosen the bolts and adjust the seat tracks.

    6. A01170K

      for LHD front passenger seat:


      1. Connect the front seat side airbag connector.

      2. Connect the front seat cushion airbag connector.

      3. Connect the buckle switch connector.

      4. Connect the front seat wire connector.

      5. Install the wiring harness clamp.

    7. A0119ZF

      for RHD front passenger seat:


      1. Connect the front seat side airbag connector.

      2. Connect the front seat cushion airbag connector.

      3. Connect the buckle switch connector.

      4. Connect the front seat wire connector.

      5. Install the wiring harness clamp.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  4. INSPECT SRS WARNING LIGHT

    Click here.