REAR SEAT OUTER BELT ASSEMBLY INSTALLATION

Tech Tips

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


  1. INSTALL REAR SEAT OUTER BELT ASSEMBLY


    1. A0117AYE01

      Check the angle of inclination required to lock the retractor.


      1. Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.

        Note

        Do not disassemble the retractor.

        If the operation is not as specified, replace the rear seat outer belt.

    2. A011BUPE01

      Hook the lower stay of the retractor onto the 2 body hooks and install the retractor with the 2 bolts.

      Torque:
      for Bolt A
      4.8 N*m  { 49 kgf*cm, 42 in.*lbf }
      Torque:
      for Bolt B
      41 N*m  { 420 kgf*cm, 30 ft.*lbf }
    3. A0118N5

      Install the through anchor with the bolt.

      Torque:
      41 N*m  { 420 kgf*cm, 30 ft.*lbf }

    4. Engage the 2 claws and install the seat belt anchor cover cap.

    5. A0118OK

      Install the rear seat outer belt anchor plate with the bolt.

      Torque:
      41 N*m  { 420 kgf*cm, 30 ft.*lbf }

    6. Check that the ELR locks.

      Note

      Perform the check with the rear seat outer belt installed.


      1. With the belt installed, check that the belt locks when it is pulled out quickly.

        If the operation is not as specified, replace the rear seat outer belt.

  2. INSTALL NO. 1 SIDE TRIM ASSEMBLY RH

    A0119QR

    1. Engage the 6 clips and install the side No. 1 trim.

  3. INSTALL DECK TRIM SIDE BELT HOLE COVER RH

    A011AN1

    1. Engage the 5 claws and install the deck trim side belt hole cover.

  4. INSTALL BACK DOOR WEATHERSTRIP

  5. INSTALL REAR DECK TRIM COVER

    A0116Z2

    1. Engage the 6 claws.

    2. Install the rear deck trim cover with the 2 clips.

  6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

  7. INSTALL FRONT DOOR SCUFF PLATE RH

    A011AJ3

    1. Engage the 9 claws and install the front door scuff plate.

  8. INSTALL REAR SEAT ASSEMBLY


    1. Install the rear seat assembly Click here.