REAR AIRBAG SENSOR REMOVAL

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

Tech Tips

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  2. REMOVE REAR SEAT ASSEMBLY


    1. Remove rear seat assembly Click here.

  3. REMOVE FRONT DOOR SCUFF PLATE RH

    A011AJ3

    1. Disengage the 9 claws and remove the front door scuff plate.

  4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH


    1. Remove the front door opening trim weatherstrip to the extent that the side No. 1 trim assembly RH can be removed.

  5. REMOVE REAR DECK TRIM COVER

    A0116Z2

    1. Remove the 2 clips.

    2. Disengage the 6 claws and remove the rear deck trim cover.

  6. REMOVE BACK DOOR WEATHERSTRIP


    1. Remove the back door weatherstrip to the extent that the side No. 1 trim assembly RH can be removed.

  7. REMOVE DECK TRIM SIDE BELT HOLE COVER RH

    A011AN1

    1. Disengage the 5 claws and remove the deck trim side belt hole cover.

  8. REMOVE NO. 1 SIDE TRIM ASSEMBLY RH

    A0119QR

    1. Disengage the 6 clips and remove the side No. 1 trim.

  9. REMOVE REAR AIRBAG SENSOR

    CAUTION:

    Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.


    1. A011A6XE01
      Text in Illustration
      *1 Outer Housing

      Slide the outer housing and detach the airbag connector.

    2. A0119DN

      Disengage the bolt and hook and remove the airbag sensor.