SIDE AIRBAG SENSOR (for Rear) INSTALLATION

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

Tech Tips

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


  1. INSTALL SIDE AIRBAG SENSOR


    1. Confirm that the ignition switch is off.

    2. Confirm that the cable to the negative battery terminal is disconnected.

      CAUTION:


      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

    3. A011BGH

      Insert the hook into the body hole and install the airbag sensor with the bolt.

      Torque:
      9.0 N*m  { 90 kgf*cm, 80 ft.*lbf }

      Note


      • Do not use a side airbag sensor that has been dropped.

      • Do not subject the side airbag sensor to any impact or force.

    4. Confirm that there is no looseness by shaking the side airbag sensor.

    5. A011AGZE01
      Text in Illustration
      *1 Outer Housing

      Connect the airbag connector.

  2. INSTALL NO. 1 SIDE TRIM ASSEMBLY RH

    A0119QR

    1. Engage the 6 clips and install the side No. 1 trim.

  3. INSTALL DECK TRIM SIDE BELT HOLE COVER RH

    A011AN1

    1. Engage the 5 claws and install the deck trim side belt hole cover.

  4. INSTALL BACK DOOR WEATHERSTRIP

  5. INSTALL REAR DECK TRIM COVER

    A0116Z2

    1. Engage the 6 claws.

    2. Install the rear deck trim cover with the 2 clips.

  6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

  7. INSTALL FRONT DOOR SCUFF PLATE RH

    A011AJ3

    1. Engage the 9 claws and install the front door scuff plate.

  8. INSTALL REAR SEAT SUB FLOOR BOARD ASSEMBLY (w/o Rear Seat Assembly)

    A0118Y8

    1. Install the rear floor board with the 6 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

  9. INSTALL REAR SEAT ASSEMBLY (w/ Rear Seat Assembly)


    1. Install rear seat assembly Click here.

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  11. INSPECT SRS WARNING LIGHT


    1. Inspect SRS warning light Click here.