CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.


  1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY

    A011AU9

    1. Confirm that the ignition switch is off.

    2. Confirm that the cable to the negative battery terminal is disconnected.

      CAUTION:


      • Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Install the airbag sensor with the 3 bolts.

      Torque:
      17.5 N*m  { 178 kgf*cm, 13 ft.*lbf }

      Note


      • Do not use an airbag sensor that has been dropped.

      • Do not subject the airbag sensor to any impact or force.

      • Confirm that the carpet does not interfere with the installation plane.

    4. Confirm that there is no looseness by shaking the front airbag sensor.

    5. A011BERE02
      Text in Illustration
      *1 Lever

      Connect the connector holder to lock the lever.

      Note

      Confirm that the lever is locked.

    6. A0117FK

      Confirm that the drip-proof sheet has not been removed and does not cut into the connectors.

  2. INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY (for EE53)


    1. Install the floor shift shift lever assembly Click here.

  3. INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY (for EE65)


    1. Install the floor shift shift lever assembly Click here.

  4. INSTALL SHIFT LEVER ASSEMBLY (for CVT)


    1. Install the shift lever assembly Click here.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  6. INSPECT SRS WARNING LIGHT

    Click here.