ENTRY AND START SYSTEM (for Entry Function) Back Door Entry Lock Function does not Operate

DESCRIPTION

If the back door entry lock function does not operate but the back door open function operates, the communication between the vehicle and electrical key transmitter is normal. The malfunctioning part may be the entry lock switch circuit (certification ECU ← back door outside handle (lock switch)).

WIRING DIAGRAM

A011BP8E01

INSPECTION PROCEDURE

Note


  • The entry and start system (for entry function) uses a multiplex communication system (LIN communication system) and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting Click here. Troubleshoot the entry and start system (for entry function) after confirming that the communication system is functioning properly.

  • When using the intelligent tester with the engine switch off to troubleshoot: Connect the intelligent tester to the DLC3, and turn a courtesy light switch on and off at 1.5-second intervals until communication between the tester and vehicle begins.

PROCEDURE


  1. CHECK POWER DOOR LOCK OPERATION


    1. When the back door open switch on the back door outside handle is operated, check that the doors unlock according to switch operation Click here.

      OK
      Door unlocks operate normally.

    NG

    GO TO POWER DOOR LOCK CONTROL SYSTEM (PROCEED TO PROBLEM SYMPTOMS TABLE) Click here

    OK

  2. READ VALUE USING INTELLIGENT TESTER (TR/B-DOOR LOCK SW)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Entry & Start / Data List.

    5. Read the Data List according to the display on the intelligent tester.

      Entry and Start
      Tester Display Measurement Item/Display Normal Condition Diagnostic Note
      Tr/B-Door Lock SW Back door lock switch / ON or OFF

      ON: Back door lock switch pushed

      OFF: Back door lock switch not pushed

      		 -
      OK
      On the intelligent tester screen, the display changes between ON and OFF as shown in the table above.

    NG

    CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BACK DOOR LOCK SWITCH AND BODY GROUND) Click here

    OK

    REPLACE CERTIFICATION ECU

  3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BACK DOOR LOCK SWITCH AND BODY GROUND)


    1. A0118PIE01
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Back Door Outside Handle)
      *2

      Front view of wire harness connector

      (to Certification ECU)

      Disconnect the certification ECU connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D34-23 (TSW6) - J6-4 (B) Always Below 1 Ω
      J6-3 (L) - Body ground Always Below 1 Ω
      D34-23 (TSW6) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. INSPECT BACK DOOR OUTSIDE HANDLE


    1. A011BFGE01
      Text in Illustration
      *1

      Component without harness connected

      (to Back Door Outside Handle)

      Remove the back door outside handle Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      4 (B) - 3 (L) Back door lock switch not pushed (OFF) 10 kΩ or higher
      4 (B) - 3 (L) Back door lock switch pushed (ON) Below 1 Ω

    NG

    REPLACE BACK DOOR OUTSIDE HANDLE Click here

    OK

    REPLACE CERTIFICATION ECU