BACK DOOR LOCK INSPECTION


  1. INSPECT BACK DOOR LOCK ASSEMBLY


    1. A0119A4E15
      Text in Illustration
      *1

      Component without harness connected

      (Back Door Lock)

      Check the operation.


      1. Move the back door lock to the lock position.

      2. Connect the positive (+) lead from the battery to terminal 2 (ACT+) and the negative (-) lead to terminal 1 (ACT-), and then check that the unlocks.

        OK
        Unlocks

        If the result is not as specified, replace the back door lock.

    2. A0119A4E16
      Text in Illustration
      *1

      Component without harness connected

      (Back Door Lock)

      Check operation of the back door courtesy switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        1 (ACT-) - 3 (D+) Locked 10 kΩ or higher
        1 (ACT-) - 3 (D+) Unlocked Below 1 Ω

        If the result is not specified, replace the back door lock.