UNLOCK WARNING SWITCH INSTALLATION


  1. INSTALL UNLOCK WARNING SWITCH ASSEMBLY


    1. A011BQU

      Slide and engage the 2 claws and install the unlock warning switch.

  2. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY


    1. Turn the ignition switch to ACC.

    2. A011987E01
      Text in Illustration
      *1 START
      *2 ON
      *3 ACC
      *4 LOCK

      Install the ignition switch lock cylinder assembly into the steering column bracket assembly upper.

    3. Make sure that the ignition switch lock cylinder assembly is securely fixed onto the ignition switch lock cylinder assembly.

  3. INSTALL KEY INTER LOCK SOLENOID (except Manual Transaxle without Smart Entry and Start System)

    A0119IY

    1. Connect the terminals (3) and (4) to the connector as shown in the illustration.

    2. Push in the stopper.

    3. A01199T

      Install the key interlock solenoid onto the steering column bracket assembly upper with the 2 screws.

  4. INSTALL IGNITION SWITCH ASSEMBLY

    A01197E

    1. Install the ignition switch assembly onto the steering column bracket assembly upper with the 2 screws.

  5. INSTALL TRANSPONDER KEY AMPLIFIER

    A0118U6

    1. Engage the 2 claws and install the transponder key amplifier onto the steering column upper with the switch bracket.

  6. INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY


    1. Fix the steering column assembly in a vise between aluminum plates.

      Note

      Do not overtighten the vise.

    2. A0119C2

      Install the steering column upper with switch bracket assembly and steering column clamp upper with new steering lock set bolt, and then tighten the bolt until the head comes off.

  7. INSTALL STEERING COLUMN ASSEMBLY


    1. Install the steering column assembly Click here.