DOOR CONTROL TRANSMITTER INSPECTION


  1. INSPECT DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY


    1. Inspect operation of the door control transmitter module set sub-assembly.


      1. A0119WY

        Install a new or non-depleted transmitter battery Click here.

        Tech Tips

        When a new or non-depleted transmitter battery is not available, first connect 2 new 1.5 V batteries in series. Then connect leads to the batteries and apply 3 V to the door control transmitter module set sub-assembly, as shown in the illustration.

      2. From outside the vehicle, approximately 1 m (3.28 ft.) from the driver door outside door handle, test the door control transmitter module set sub-assembly by pointing its key plate at the vehicle and pressing a door control transmitter module set sub-assembly switch.

        OK
        The door lock can be operated via the door control transmitter module set sub-assembly.

        Tech Tips


        • The operational area differs depending on the user, the way the door control transmitter module set sub-assembly is held and the location.

        • The door control transmitter module set sub-assembly uses weak radio waves that may be affected if the area has strong radio waves or electrical noise. The door control transmitter module set sub-assembly operation area may be shortened or the door control transmitter module set sub-assembly may not function.

    2. Inspect the transmitter battery capacity.


      1. Attach a lead wire (0.6 mm (0.0236 in.) in diameter or less including wire sheath) with tape or equivalent to the negative terminal.

        Note

        Do not wrap the lead wire around a terminal, wedge it between the terminals, or solder it. A terminal may be deformed or damaged, and the battery will not be able to be installed correctly.

      2. A01174FE06
        Text in Illustration
        *a Lead Wire

        Carefully pull the lead wire out from the position shown in the illustration and install the previously removed transmitter battery Click here.

      3. A011BRR

        Check the transmitter battery voltage.

        Tech Tips

        Measure the transmitter battery voltage while pressing the lock or unlock switch on the door control transmitter module set sub-assembly.

        Standard Voltage
        Tester Connection Switch Condition Specified Condition
        Battery positive (+) - Battery negative (-) Ignition switch off, all doors closed and lock or unlock switch is pressed 2.5 to 3.2 V

        If the result is not as specified, replace the transmitter battery.