TRANSMITTER BATTERY (w/o Entry and Start System) REPLACEMENT


  1. REMOVE TRANSMITTER HOUSING COVER


    1. A0117YOE01
      Text in Illustration
      *a Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, pry apart the transmitter housing cover as shown in the illustration.

      Note


      • Do not use excessive force when prying apart the transmitter housing cover.

      • Remove the transmitter housing cover while the switches face downward to prevent the switch knob from falling.

  2. REMOVE DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY


    1. A0119FK

      Remove the door control transmitter module set sub-assembly.

  3. REMOVE TRANSMITTER BATTERY


    1. A0118T9

      Disengage the 2 claws and remove the transmitter battery cover.

    2. A0118D7

      Remove the transmitter battery, as shown in the illustration.

      Note


      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.

      • Do not push the terminals with your finger.

      • Do not use excessive force when prying up the transmitter battery as this may damage the terminals.

      • Do not touch the transmitter battery with wet hands. Water may cause it to rust.

      • Do not touch or move any components inside the transmitter as this may interfere with its proper operation.

  4. INSTALL TRANSMITTER BATTERY


    1. A0119LE

      Install the transmitter battery with the positive (+) side facing upward, as shown in the illustration.

      Note


      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.

      • Make sure that the positive (+) side and the negative (-) side of the transmitter battery are correctly matched with the transmitter terminals.

      • Do not bend the transmitter battery electrode during insertion.

      • Keep the transmitter battery cover interior free of dust and oil.

    2. Engage the 2 claws and install the transmitter battery cover.

  5. INSTALL DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY


    1. A011BAR

      Install the door control transmitter module set sub-assembly, as shown in the illustration.

      Note

      The switches may not be able to operate normally when the door control transmitter module set sub-assembly is installed while keeping its rubber projections bent.

  6. INSTALL TRANSMITTER HOUSING COVER


    1. A011B0X

      Install the transmitter housing cover, as shown in the illustration.