NOISE FILTER REMOVAL


  1. REMOVE BOX ASSEMBLY


    1. A011BKK

      Pull up the deck board assembly.

    2. Release the 2 knobs and remove the box assembly.

  2. REMOVE FRONT DOOR SCUFF PLATE LH

    Tech Tips

    Use the same procedures described for the RH side Click here.

  3. REMOVE REAR DECK TRIM COVER

    A0116Z2

    1. Remove the 2 clips.

    2. Disengage the 6 claws and remove the rear deck trim cover.

  4. REMOVE DECK TRIM SIDE BELT HOLE COVER LH

    Tech Tips

    Use the same procedures described for the RH side Click here.

  5. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

  6. REMOVE SIDE NO. 1 TRIM ASSEMBLY LH

    Tech Tips

    Use the same procedures described for the RH side Click here.

  7. REMOVE RADIO SETTING CONDENSER

    Note

    The terminal cover and condenser are a single part. When the terminal cover is removed, the entire radio setting condenser must be replaced.


    1. A0118M1

      Remove the bolt.

    2. Disengage the clamp and separate the radio setting condenser and the vehicle wire harness from the back panel.

    3. A011A9ME01
      Text in Illustration
      *1 Protective tape

      Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the terminal cover together with the wire harness, as shown in the illustration.

    4. Using a screwdriver, break the claw on the terminal cover to remove it from the vehicle wire harness.

      A0119QG