STEERING PAD SWITCH INSTALLATION


  1. INSTALL STEERING PAD SWITCH LH


    1. A0119AA

      Engage the claw and 2 pins.

    2. Install the steering pad switch LH with the screw.

    3. Secure the wire harness on the damper hook.

    4. Connect the connector.

  2. INSTALL STEERING PAD ASSEMBLY

    A0116YBE01

    Note

    Do not use a steering pad that has been dropped.

    Text in Illustration
    *1 Locking Button

    1. Confirm that the ignition switch is off.

    2. Confirm that the cable to the negative battery terminal is disconnected.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Connect the horn terminal.

    4. Connect the airbag connector.

      Note


      • Match the color of the airbag connector with that of the steering pad assembly, and install the airbag connector.

      • Securely lock the locking button.

    5. A011BHG

      Engage the pins into the spring clips behind the horn button assembly to install the steering pad.

      Note

      Pull the horn button assembly to ensure that it is securely engaged.

      Tech Tips

      Install the right-side pin of the horn button assembly first.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  4. INSPECT SRS WARNING LIGHT

    Click here