STEERING GEAR INSPECTION


  1. INSPECT TIE ROD END SUB-ASSEMBLY LH


    1. A0119PZ

      Secure the tie rod end sub-assembly LH in a vise.

      Note

      Do not overtighten the vise.

    2. Install the nut onto the stud bolt.

    3. Flip the ball joint back and forth 5 times.

    4. Set a torque wrench to the nut, turn the ball joint continuously at a rate of 2 to 4 seconds per turn, and check the turning torque on the 5th turn.

      Standard turning torque
      0.49 to 3.43 N*m (5.0 to 35.0 kgf*cm, 4.34 to 30.4 in.*lbf)

      Tech Tips

      If turning torque is not within the specified range, replace the tie rod end sub-assembly LH with a new one.

  2. INSPECT TIE ROD END SUB-ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LH side.

  3. INSPECT TOTAL PRELOAD


    1. A0117W0E01

      Using SST and a torque wrench, inspect the total preload.

      SST
      09616-00011
      Standard preload
      1.0 to 1.6 N*m (10.2 to 16.3 kgf*cm, 8.9 to 14.2 in.*lbf)

      Note

      Inspect around the steering rack center position.

      Tech Tips

      If the total preload is not within the specified range, replace the steering gear assembly with a new one.