REAR BRAKE (for Drum Type) INSPECTION


  1. INSPECT BRAKE CYLINDER AND PISTON


    1. Check the cylinder bore and piston for rust and scoring. If necessary, replace the brake cylinder assembly or piston.

  2. INSPECT BRAKE DRUM INSIDE DIAMETER


    1. A011B8CE03
      Text in Illustration
      *1 Brake Drum Gauge

      Using a brake drum gauge or an equivalent tool, measure the inside diameter of the drum.

      Standard inside diameter
      180.0 mm (7.09 in.)
      Maximum inside diameter
      181.0 mm (7.13 in.)

      If the inside diameter is more than the maximum, replace the drum.

  3. INSPECT REAR BRAKE SHOE LINING THICKNESS


    1. A011B54E04
      Text in Illustration
      *1 Ruler

      Using a ruler, measure the thickness of the shoe lining.

      Standard thickness
      4.0 mm (0.157 in.)
      Minimum thickness
      1.0 mm (0.0394 in.)

      If the lining thickness is less than the minimum, or if there is severe or uneven wear, replace the brake shoe.

      Note

      Always replace both the right and left drum brake shoes together.

  4. INSPECT BRAKE DRUM AND DRUM BRAKE SHOE LINING FOR PROPER CONTACT


    1. A01191E

      Apply chalk to the inside surface of the drum, and then grind down the brake shoe lining to fit the drum.

      If the contact between the drum and the brake shoe lining is improper, repair it using a brake shoe grinder or replace the brake shoe.