FRONT SPEED SENSOR INSTALLATION


  1. INSTALL FRONT SPEED SENSOR


    1. Install the front speed sensor with the bolt A.

      A01198WE01
      Text in Illustration
      *1 No. 1 Sensor Clamp *5 Bolt B
      *2 No. 2 Sensor Clamp *6 Bolt C
      *3 No. 3 Sensor Clamp *7 Nut
      *4 Bolt A *8 Speed Sensor Connector
      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Prevent foreign matter from attaching to the sensor tip.

      • Do not file the sensor installation hole or surface because the gap between the magnet rotor and front speed sensor is important.

    2. Install the No. 1 sensor clamp and flexible hose with the bolt B.

      Torque:
      29 N*m  { 300 kgf*cm, 22 ft.*lbf }

      Note


      • Do not twist the front speed sensor wire harness during installation.

      • Tighten the brake flexible hose and front speed sensor together with the bolt. Make sure that the flexible hose is positioned over the front speed sensor.

    3. Install the No. 2 sensor clamp to the shock absorber with the bolt C.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

    4. Connect the speed sensor connector.

    5. Install the No. 3 sensor clamp to the body with the nut.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

  2. INSTALL WIRE HARNESS (for RH Side)


    1. A011BI3

      Engage the clamp from the No. 3 sensor clamp.

  3. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY


    1. A011BS6

      Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    2. A011BX5

      Remove the 7 clips.

    3. Remove the 3 grommets and remove the front fender splash shield.

      Tech Tips

      Replace the grommets with new ones if they are damaged during removal.

  4. INSTALL FENDER REAR PLATE MUDGUARD

    A011973

    1. Install the fender rear plate mudguard with the grommet.

    2. Install the clip and screw.

  5. INSTALL FRONT WHEEL OPENING EXTENSION PAD

    A011BPD

    1. Install the front wheel opening extension pad with the 2 screws.

  6. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  7. CHECK FOR SPEED SENSOR SIGNAL

    Click here