VEHICLE STABILITY CONTROL SYSTEM DIAGNOSTIC TROUBLE CODE CHART
Note
Turn the ignition switch off before removing parts.
Tech Tips
-
If no abnormality is found when inspecting parts, inspect the skid control ECU and ground points for poor contact.
-
If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to the page for the respective "DTC Code" in the DTC chart.
-
When 2 or more DTCs are detected, perform circuit inspection one by one until the problem is identified.
| DTC Code | Detection Item | See page |
|---|---|---|
| C0226 | SFR Solenoid Circuit | |
| C0236 | SFL Solenoid Circuit | |
| C0246 | SRR Solenoid Circuit | |
| C0256 | SRL Solenoid Circuit | |
| C0273*1 | Open in ABS Motor Relay Circuit | |
| C0274 | Short in ABS Motor Relay Circuit | |
| C0278 | Open in ABS Solenoid Relay Circuit | |
| C0279 | Short in ABS Solenoid Relay Circuit | |
| C1225 | SM Solenoid Circuit | |
| C1241 | Low Power Supply Voltage Malfunction | |
| C1243*1 | Acceleration Sensor Stuck Malfunction | |
| C1245*1 | Acceleration Sensor Output Malfunction | |
| C1361 | Short in ABS Motor Fail Safe Relay Circuit | |
| C1381 | Acceleration Sensor Power Supply Voltage Malfunction | |
| C1401*1 | Front Speed Sensor RH Malfunction | |
| C1402*1 | Front Speed Sensor LH Malfunction | |
| C1403*1 | Rear Speed Sensor RH Malfunction | |
| C1404*1 | Rear Speed Sensor LH Malfunction | |
| C1405*1 | Open or Short in Front Speed Sensor RH Circuit | |
| C1406*1 | Open or Short in Front Speed Sensor LH Circuit | |
| C1407*1 | Open or Short in Rear Speed Sensor RH Circuit | |
| C1408*1 | Open or Short in Rear Speed Sensor LH Circuit | |
| C1413*1 | Front Speed Sensor RH Output Malfunction | |
| C1414*1 | Front Speed Sensor LH Output Malfunction | |
| C1415*1 | Rear Speed Sensor RH Output Malfunction | |
| C1416*1 | Rear Speed Sensor LH Output Malfunction | |
| C1417 | High Power Supply Voltage Malfunction | |
| C1419 | Acceleration Sensor Internal Circuit | |
| C1420 | Acceleration Sensor Malfunction | |
| C1421*2 | Open or Short in Master Cylinder Pressure Sensor | |
| C1422*2 | Master Cylinder Pressure Sensor Zero Point High Malfunction | |
| C1423*2 | Master Cylinder Pressure Sensor Zero Point Low Malfunction | |
| C1424*2 | Master Cylinder Pressure Sensor Output Malfunction | |
| C1425 | Open in Stop Light Switch Circuit | |
| C1427*1 | Motor Malfunction | |
| C1428*1 | Motor Circuit Malfunction | |
| C1442 | Invalid Data Received from Acceleration Sensor | |
| U0073 | Control Module Communication Bus OFF | |
| U0124 | Lost Communication with Lateral Acceleration Sensor Module |
*1, *2:
Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed:
-
*1:
-
Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.
-
Clear the DTC.
-
*2:
-
Keep the vehicle stationary for 5 seconds or more and depress the brake pedal lightly 2 or 3 times.
-
Drive the vehicle at a vehicle speed of 50 km/h (31 mph) and keep depressing the brake pedal strongly for approximately 3 seconds.
-
Repeat the above operation 3 times or more and check that the ABS warning light goes off.
-
Clear the DTC.
Tech Tips
In some cases, the GTS cannot be used when the ABS warning light remains on.
| DTC Code | Detection Item | See page |
|---|---|---|
| 43 | ABS Control System Malfunction | |
| C1201 | Engine Control System Malfunction | |
| C1203 | ECM Communication Circuit Malfunction | |
| C1210 | Zero Point Calibration of Yaw Rate Sensor Undone | |
| C1232 | Acceleration Sensor Stuck Malfunction | |
| C1290 | Steering Angle Sensor Zero Point Malfunction | |
| C1336 | Zero Point Calibration of Acceleration Sensor Undone | |
| C1432 | Steering Angle Sensor Power Source Voltage Malfunction | |
| C1433 | Steering Angle Sensor Internal Circuit | |
| C1434 | Steering Angle Sensor Output Malfunction | |
| C1435 | Yaw Rate Sensor Internal Circuit | |
| C1436 | Yaw Rate Sensor Malfunction | |
| C1437 | Lost Communication with ECM | |
| C1439 | Steering Angle Sensor Initialization Incomplete | |
| C1440 | Steering Angle Sensor Unusual Bank Angle Detected | |
| C1443 | Invalid Data Received from Yaw Rate Sensor | |
| C1445 | Vehicle Driven with Steering Angle Sensor not Initialized | |
| U0100 | Lost Communication with ECM / PCM | |
| U0123 | Lost Communication with Yaw Rate Sensor Module | |
| U0126 | Lost Communication with Steering Angle Sensor Module |
Tech Tips
In some cases, the GTS cannot be used when the SLIP indicator light remains on.
| DTC Code | Detection Item | See page |
|---|---|---|
| C1271 | Low Output Signal of Front Speed Sensor RH (Test Mode DTC) | |
| C1272 | Low Output Signal of Front Speed Sensor LH (Test Mode DTC) | |
| C1273 | Low Output Signal of Rear Speed Sensor RH (Test Mode DTC) | |
| C1274 | Low Output Signal of Rear Speed Sensor LH (Test Mode DTC) | |
| C1275 | Abnormal Change in Output Signal of Front Speed Sensor RH (Test Mode DTC) | |
| C1276 | Abnormal Change in Output Signal of Front Speed Sensor LH (Test Mode DTC) | |
| C1277 | Abnormal Change in Output Signal of Rear Speed Sensor RH (Test Mode DTC) | |
| C1278 | Abnormal Change in Output Signal of Rear Speed Sensor LH (Test Mode DTC) | |
| C1279 | Acceleration Sensor Output Voltage Malfunction (Test Mode DTC) | |
| C1281 | Master Cylinder Pressure Sensor Output Malfunction (Test Mode DTC) |