CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM, Diagnostic DTC:P282B

DTC Code DTC Name
P282B Pressure Control Solenoid "K" Electrical (Shift Solenoid Valve SLS)

DESCRIPTION

The ECM uses the SLS solenoid valve to control the secondary pulley pressure and belt clamping pressure according to the input shaft torque force. Additionally, solenoid SLS is used to control the forward clutch hydraulic pressure when the forward clutch is engaged and the neutral control is operating.

DTC No.

DTC Detection Condition


  1. Diagnosis Condition

  2. Malfunction Status

  3. Malfunction Time

  4. Other

 Trouble Area
P282B

  1. During driving

  2. Open or short in belt clamping pressure liner solenoid SLS circuit

  3. 1 second

  4. 1-trip detection logic

  • Open or short in belt clamping pressure liner solenoid SLS circuit

  • Continuously variable transaxle assembly

  • ECM

MONITOR DESCRIPTION

These DTCs indicate an open or short in the belt clamping pressure liner solenoid SLS circuit. When there is an open or short circuit in any belt clamping pressure liner solenoid valve circuits, the ECM detects the problem, illuminates the MIL and stores the DTC.

WIRING DIAGRAM

A011AFHE01

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY (BELT CLAMPING PRESSURE LINER SOLENOID SLS)


    1. A011BRAE05
      Text in Illustration
      *1

      Component without wire harness connected:

      (Continuously Variable Transaxle Assembly

      (Transmission Wire))

      Disconnect the transmission wire connector from the transaxle.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      2 (SLU+) - 7 (SLU-) 20°C (68°F) 5.0 to 5.6 Ω

    NG

    REPLACE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM)


    1. A01185NE05
      Text in Illustration
      *1

      Front view of wire harness connector:

      (to ECM)

      Reconnect the transmission wire connector.

    2. Disconnect the ECM connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      B8-54 (SLS+) - B8-53 (SLS-) 20°C (68°F) 5.0 to 5.6 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. REPLACE ECM


    1. Replace ECM Click here.


    NEXT

  4. PERFORM INITIALIZATION


    1. Perform the initialization Click here.

    2. Check for DTCs again Click here.


    NEXT

    END

  5. REPLACE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY


    1. Replace continuously variable transaxle assembly Click here.


    NEXT

  6. PERFORM INITIALIZATION


    1. Perform the initialization Click here.

    2. Check for DTCs again Click here.


    NEXT

    END