SHIFT LEVER INSTALLATION


  1. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    1. Install the shift lever knob onto the shift lever.

  2. INSTALL SHIFT LEVER ASSEMBLY


    1. Install the shift lever with the 4 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

      Note

      Make sure that the instrument panel wire is not caught under the shift lever.

    2. Engage the 4 clamps and install the instrument panel wire onto the shift lever.

    3. Connect the 2 connectors to the shift lever.

  3. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A0117XQE01
      Text in Illustration
      *1 Nut
      *2 Lock

      Rotate the transmission control cable nut counterclockwise 180° and push in the lock while holding the nut.

    2. A011AO4E01
      Text in Illustration
      *1 Lock
      *2 Shift Lever Plate

      Install the transmission control cable's cable outer onto the shift lever plate.

      Note

      After installation, check that the cable outer lock extends past the line A-A, as shown in the diagram.

    3. Confirm that the shift lever is in N and install the cable end to the shift lever.

      Note


      • Push the cable end to the base of the pin to be sure that it is installed securely.

      • Install the cable end adjustment mechanism so that the lock faces the driver seat.

  4. INSPECT SHIFT LEVER POSITION


    1. Turn the ignition switch to ON and step on the brake pedal.

    2. Confirm that the shift lever moves smoothly through all of the shift positions and the position indicator shows the correct shift lever position.

    3. Start the engine and confirm that the vehicle moves forward when the shift lever is moved from N to D.

  5. ADJUST SHIFT LEVER POSITION


    1. Remove the console panel upper Click here.

    2. Move the shift lever to N.

    3. A011ALNE01
      Text in Illustration
      *1 Adjuster Case
      *2 Cover
      *3 Lock Piece

      Slide the adjuster case cover in the direction shown by the arrow.

    4. Using a precision screwdriver, pull up the lock piece.

    5. A0117N3E01
      Text in Illustration
      *1 Adjuster Case
      *2 Lock Piece
      *3 Cable Rod
      *4 Cover

      Press the lock piece into the adjuster case.

      Tech Tips

      Lightly pull the cable rod towards the back of the vehicle to eliminate slack, and then lock the adjuster.

    6. Slide the adjuster case cover in the direction shown by the arrow.

      Note

      If the cover is not pushed over the protrusion on the lock, the cable will not lock and shift operation will not be accurate.

    7. Install the console panel upper Click here.

  6. INSTALL REAR CONSOLE BOX ASSEMBLY


    1. Install the rear console box ( Click here).