TRANSMISSION CONTROL CABLE INSTALLATION


  1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A0118NE

      Pass the transmission control cable into the vehicle and install the transmission control cable to the body, using the 3 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }
    2. A0117CZ

      Install the transmission control cable to the No. 1 transmission control cable bracket, using a new clip.

    3. A011AKJ

      Using the nut, connect the transmission control cable to the transmission control shaft lever.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

      Note

      Check that the park/neutral position switch is in the N position.

    4. A0117XQE01
      Text in Illustration
      *1 Nut
      *2 Lock

      Rotate the transmission control cable nut counterclockwise 180° and push in the lock while holding the nut.

    5. A011AO4E01
      Text in Illustration
      *1 Lock
      *2 Shift Lever Plate

      Install the transmission control cable's cable outer onto the shift lever plate.

      Note

      After installation, check that the cable outer stopper extends past the line A-A, as shown in the diagram.

    6. A0118JS

      Confirm that the shift lever is in N and install the cable end to the shift lever.

      Note


      • Push the cable end to the base of the pin to be sure that it is installed securely.

      • Install the cable end adjustment mechanism so that the lock faces the driver seat.

  2. ADJUST SHIFT LEVER POSITION


    1. Remove the console panel upper Click here.

    2. Move the shift lever to N.

    3. A011ALNE01
      Text in Illustration
      *1 Adjuster Case
      *2 Cover

      Slide the adjuster case cover in the direction shown by the arrow.

    4. Using a precision screwdriver, pull up the lock piece.

      Text in Illustration
      *3 Lock Piece
    5. A0117N3E01
      Text in Illustration
      *1 Adjuster Case
      *2 Lock Piece
      *3 Cable Rod

      Press the lock piece into the adjuster case.

      Tech Tips

      Lightly pull the cable rod towards the back of the vehicle to eliminate slack, and then lock the adjuster.

    6. Slide the adjuster case cover in the direction shown by the arrow.

      Text in Illustration
      *1 Adjuster Case
      *4 Cover

      Note

      If the cover is not pushed over the protrusion on the lock, the cable will not lock and shift operation will not be accurate.

    7. Install the console panel upper Click here.

  3. INSPECT SHIFT LEVER POSITION


    1. Turn the ignition switch to ON and step on the brake pedal.

    2. Confirm that the shift lever moves smoothly through all of the shift positions and the position indicator shows the correct shift lever position.

    3. Start the engine and confirm that the vehicle moves forward when the shift lever is moved from N to D.

  4. INSTALL REAR CONSOLE BOX ASSEMBLY


    1. Install the rear console box ( Click here).