CLUTCH PEDAL (for RHD) ADJUSTMENT


  1. INSPECT AND ADJUST CLUTCH PEDAL


    1. Pull back the floor carpet.

    2. A01197XE02
      Text in Illustration
      *1 Clutch switch assembly
      *2 Adjusting nut
      *a Clutch pedal height

      Check that the pedal height is correct.

      Pedal height from floor
      for 1KR-FE, 1NR-FE
      124.9 to 134.9 mm (4.917 to 5.311 in.)
      for 1ND-TV
      136.7 to 146.7 mm (5.382 to 5.776 in.)

    3. If the pedal height is not as specified, adjust it as follows.


      1. Loosen the adjusting nut and turn the clutch pedal switch until the correct height is obtained.

      2. Tighten the adjusting nut.

        Torque:
        16 N*m  { 160 kgf*cm, 12 ft.*lbf }

  2. INSPECT AND ADJUST PEDAL FREE PLAY AND PUSH ROD PLAY


    1. A011B4ME01
      Text in Illustration
      *1 Push rod
      *2 Push rod play and free play adjust point
      *a Push rod play
      *b Pedal free play

      Check that the pedal free play and push rod play are correct.


      1. Depress the pedal until clutch resistance begins to be felt.

        Pedal free play
        5.0 to 15.0 mm (0.197 to 0.591 in.)

      2. Gently depress the pedal until the resistance begins to increase a little.

        Push rod play at pedal top
        0 to 8.0 mm (0 to 0.315 in.)

    2. Adjust the pedal free play and push rod play.


      1. Loosen the lock nut and turn the push rod until the correct free play and push rod play are obtained.

      2. Tighten the lock nut.

        Torque:
        12 N*m  { 120 kgf*cm, 9 ft.*lbf }

      3. After adjusting the pedal free play, check the pedal height.

        Note

        When loosening the lock nut be sure to hold the clevis in place by its hexagonal position.

  3. INSPECT AND ADJUST CLUTCH RELEASE POINT


    1. Check the clutch release point.


      1. Pull the parking brake lever and install wheel stoppers.

      2. Start the engine and run it at idle.

      3. Without depressing the clutch pedal, slowly move the shift lever into reverse until the gears come into contact.

      4. A011AQ6E04
        Text in Illustration
        *a 25 mm (0.98 in.) or more
        *b Release point
        *c Full stroke end position
        *d Pedal stroke

        Gradually depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) up to the full stroke end position.

        Standard distance
        25 mm (0.98 in.) or more (From pedal stroke end position to release point)

        • If the distance is not as specified, perform the following operations.

        • Check pedal height.

        • Check push rod play and pedal free play.

        • Bleed the clutch line.

        • Check the clutch cover assembly and disc assembly.

        Tech Tips

        Pedal Stroke

        1KR-FE, 1NR-FE 120 to 130 mm (4.724 to 5.118 in.)
        1ND-TV 137 to 147 mm (5.394 to 5.787 in.)