MANUAL TRANSAXLE ASSEMBLY REMOVAL

Note

When the transaxle is removed, be sure to use a new clutch release with bearing cylinder assembly and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder assembly to return to its original position, and dust could damage the seal of the clutch release with bearing cylinder assembly, possibly causing clutch fluid leaks.


  1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE


    1. Remove the engine assembly with transaxle Click here.

  2. REMOVE STARTER ASSEMBLY


    1. A011B4H

      Open the terminal cap.

    2. Remove the nut and disconnect the terminal 30.

    3. Disconnect the connector.

    4. Remove the 2 bolts and the starter assembly.

  3. REMOVE MANUAL TRANSAXLE ASSEMBLY


    1. A01180M

      Remove the 8 bolts and the manual transaxle.

  4. REMOVE TRANSVERSE ENGINE ENGINE MOUNTING CONTROL BRACKET

    A011BNJ

    1. Remove the 3 bolts and the engine mounting control bracket.

  5. REMOVE TRANSVERSE ENGINE ENGINE MOUNTING BRACKET

    A0119DM

    1. Remove the 4 bolts and the engine mounting bracket LH.

  6. REMOVE CONTROL CABLE BRACKET


    1. A011ACU

      Disengage the wire harness clamps and connector from control cable bracket.

    2. Remove the 2 bolts and control cable bracket.

  7. REMOVE TRANSMISSION CASE PLUG


    1. A011871

      Remove the transmission case plug with the O-ring from the manual transaxle.

  8. REMOVE WIRE HARNESS CLAMP BRACKET


    1. A011AIO

      Remove the bolt and oxygen sensor wire harness clamp bracket.

    2. A0119B1

      Remove the bolt and wire harness clamp bracket.

  9. REMOVE NO. 1 CLUTCH HOUSING COVER

    A011BPN

    1. Remove the No. 1 clutch housing cover from the transaxle.

  10. REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY

    A0119X3

    1. Using a union nut wrench 10 mm, separate the clutch release bleeder from the bleeder clutch release tube.

    2. Remove the 2 bolts and clutch release bleeder.

  11. REMOVE BLEEDER CLUTCH RELEASE TUBE


    1. A0119VM

      Using a union nut wrench 10 mm, separate the bleeder clutch release tube.

    2. Remove the bolt and bleeder clutch release tube.

  12. REMOVE CLUTCH TUBE BOOT

  13. REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY

    A0119UV

    1. Remove the 3 bolts and the clutch release with bearing cylinder assembly together with the bleeder clutch release tube.

  14. REMOVE BLEEDER CLUTCH RELEASE TUBE

    A011BWO

    1. Using a union nut wrench 10 mm, separate the clutch release tube from the clutch release with bearing cylinder assembly.