OIL AND OIL FILTER REPLACEMENT

CAUTION:


  • Prolonged and repeated contact with engine oil will cause the loss of natural of natural oils from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.

  • Precautions should be taken when replacing engine oil to minimize the risk of your skin making contact with used engine oil. Wear protective clothing and gloves. Wash your skin thoroughly with soap and water, or use a waterless hand cleaner to remove any used engine oil. Do not use gasoline, thinners or solvents.

  • For environmental protection, used oil and used oil filters must be disposed of at designated disposal sites.


  1. DRAIN ENGINE OIL


    1. Remove the oil filler cap.

    2. Remove the oil drain plug and drain the oil into a container.

    3. Clean and install the oil drain plug with a new gasket.

      Torque:
      30 N*m  { 301 kgf*cm, 22 ft.*lbf }

  2. REMOVE OIL FILTER SUB-ASSEMBLY


    1. Using SST, remove the oil filter.

      SST
      09228-06501

  3. INSTALL OIL FILTER SUB-ASSEMBLY


    1. Clean the oil filter installation surface.

    2. Apply engine oil to a new oil filter gasket.

    3. Lightly screw the oil filter into the engine until the oil filter does not turn.

    4. Using SST, tighten the oil filter.

      SST
      09228-06501

      1. Depending on the work space available, choose from the following:

        1. If enough space is available, use a torque wrench to tighten the oil filter.

        Torque:
        10 N*m  { 102 kgf*cm, 7 ft.*lbf }

        2. If enough space is not available to use a torque wrench, tighten the oil filter an additional 3/4 turn by hand or use a standard wrench.

  4. ADD ENGINE OIL


    1. Add new engine oil and install the oil filler cap.

      Engine Oil
      Oil Grade Oil Viscosity (SAE)

      • API grade SL or SM multigrade engine oil

      • 20W-50

      • 15W-40

      • API grade SL "Energy-Conserving" "Energy-Conserving SM or ILSAC multigrade engine oil"

      • 10W-30

      • 5W-30

      • 5W-20

      • 0W-20
      Capacity
      Item Standard Condition
      Drain and refill with oil filter change 3.1 liters (3.3 US qts, 2.7 Imp. qts)
      Drain and refill without oil filter change 2.9 liters (3.1 US qts, 2.6 Imp. qts)
      Dry fill 3.4 liters (3.6 US qts, 3.0 Imp. qts)

  5. INSPECT FOR OIL LEAK