EXHAUST PIPE INSTALLATION


  1. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    1. A0117GP

      Using a vernier caliper, measure the free length of the compression springs.

      Minimum Length
      Item Length
      Front 41.5 mm (1.634 in.)

      Tech Tips

      If the length is not as specified, replace the compression spring.

    2. A01175HE07
      Text in Illustration
      *1 Gasket
      *2 Wooden Block

      Using a hammer and a wooden block, tap in the gasket until its surface is flush with the exhaust manifold.

      Note


      • Install the gasket in the correct direction.

      • Do not reuse the gasket.

      • Do not damage the gasket by dropping it, etc.

      • Do not damage the outer surface of the gasket.

      • Do not push in the gasket with the exhaust pipe when connecting it.

      • After the installation, check that the gaps between the flanges of the exhaust manifold and front exhaust pipe assembly are consistent front-to-rear and left-to-right

    3. Install the front exhaust pipe assembly to the exhaust manifold with the 2 bolts and the 2 compression springs.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  2. INSTALL TAIL EXHAUST PIPE ASSEMBLY


    1. A0118CG

      Using a vernier caliper, measure the free length of the compression springs.

      Minimum Length
      Item Length
      Rear 38.5 mm (1.594 in.)

      Tech Tips

      If the length is not as specified, replace the compression spring.

    2. Fully push a new exhaust pipe gasket onto the front exhaust pipe assembly.

      Note


      • Install the gasket in the correct direction.

      • Do not reuse the gasket.

      • Do not damage the gasket by dropping it, etc

      • Do not damage the outer surface of the gasket.

      • Do not push in the gasket with the exhaust pipe when connecting it.

      • After the installation, check that the gaps between the flanges of the front exhaust pipe assembly and tail exhaust pipe assembly are consistent front-to-rear and left-to-right

    3. Hang the tail exhaust pipe assembly with the 3 exhaust pipe supports.

    4. Install the tail exhaust pipe assembly to the front exhaust assembly with the 2 bolts and the 2 compression springs.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  3. INSPECT FOR EXHAUST GAS LEAK