FUEL INJECTOR INSPECTION


  1. INSPECT FUEL INJECTOR ASSEMBLY


    1. A0119MME02
      Text in Illustration
      *1 Ohmmeter

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 20°C (68°F) 11.6 to 12.4 Ω

        If the result is not as specified, replace the injector assembly.

    2. Check the operation.

      CAUTION:

      Perform the inspection in a well-ventilated area.

      Do not perform the inspection near any open flames.


      1. A0119FSE09
        Text in Illustration
        *1 SST (Hose)
        *2 SST (Clip)
        *3 SST (Fuel Tube Connector)
        *4 Fuel Pipe
        *5 Retainer
        *6 O-ring

        Connect SST (fuel tube connector) to SST (hose), and then connect them to the fuel pipe (vehicle side).

        SST
        09268-31012   ( 90467-13001, 95336-08070, 09268-41500 )
      2. A01174HE03
        Text in Illustration
        *1 SST (Hose)
        *2 SST (Clip)
        *3 SST (Adapter)
        *4 SST (Clamp)
        *5 Vinyl Tube

        Install the new O-ring onto the fuel injector.

      3. Connect SST (adapter and hose) to the injector, and hold the injector and union with SST (clamp).

        SST
        09268-31012   ( 09268-41110, 90467-13001, 95336-08070, 09268-41300 )

      4. Put the injector into a graduated cylinder.

        CAUTION:

        Install a suitable vinyl tube onto the injector assembly to prevent gasoline splashes.

      5. Operate the fuel pump Click here.

      6. A011APVE19
        Text in Illustration
        *1 SST (Wire)
        *a Connect

        Connect SST (wire) to the injector assembly and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.

        SST
        09842-30080
        Injection Volume
        Tester Connection Condition Specified Condition
        Positive terminal - Ground terminal Per 15 seconds

        47 to 58 cm3(2.9 to 3.5 cu in.)
        Difference between each injector
        12 cm3 (0.7 cu in.) or less

        CAUTION:

        Always do the switching at the battery side.

        If the injection volume is not as specified, replace the injector assembly.

    3. A011BQ1

      Check for leaks.


      1. In the condition above, disconnect the test probes of SST (wire) from the battery and check if the fuel leaks from the injector.

        Fuel Drop
        1 drop or less every 12 minutes