REAR CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL ENGINE REAR OIL SEAL


    1. A0118EAE01
      Text in Illustration
      *1 MP Grease

      Apply MP grease to a new oil seal lip.

    2. A011AZZE01

      Using SST and a hammer, evenly tap the oil seal until its surface is flush with the rear oil seal retainer edge.

      SST
      09223-15020
      09950-70010   ( 09951-07200 )

      Note


      • Keep the lip free from foreign materials.

      • Do not tap on the oil seal at an angle.

      • Wipe off extra grease on the crankshaft.

      Tech Tips

      The pressing-in depth should be within the range of -1 mm and 0.5 mm from the rear oil seal retainer edge.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for CVT)


    1. A011BCDE01

      Using SST, hold the crankshaft.

      SST
      09960-10010   ( 09962-01000, 09963-01000 )

    2. Clean the 6 bolts and the 6 bolt holes.

    3. A011BO1E01

      Apply adhesive to 2 or 3 threads of the bolt end.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.
    4. A0119K0E01
      Text in Illustration
      *1 Front Drive Spacer
      *2 Drive Plate
      *3 Rear Drive Plate Spacer

      Install the front drive plate spacer.

      Tech Tips

      The front spacer is reversible.

    5. Install the drive plate and rear drive plate spacer onto the crankshaft.

    6. In several steps, uniformly install and tighten the 6 bolts in the sequence shown in the illustration.

      Torque:
      78 N*m  { 800 kgf*cm, 58 ft.*lbf }

  3. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)


    1. A011BCDE01

      Using SST, hold the crankshaft.

      SST
      09960-10010   ( 09962-01000, 09963-01000 )

    2. Clean the 6 bolts and the 6 bolt holes.

    3. A011BO1E01

      Apply adhesive to 2 or 3 threads of the bolt end.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.
    4. A01199NE01

      Install the flywheel sub-assembly with the 6 bolts in the order shown in the illustration.

      Torque:
      78 N*m  { 800 kgf*cm, 58 ft.*lbf }

  4. INSTALL CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY (for CVT)


    1. Install the continuously variable transaxle assembly Click here.

  5. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transaxle)


    1. Install the clutch disc assembly Click here.