AIR FUEL RATIO SENSOR INSTALLATION


  1. INSTALL AIR FUEL RATIO SENSOR


    1. A0118Q3E01
      Text in Illustration
      *a Fulcrum Length

      Using SST, install the air fuel ratio sensor.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Tech Tips


      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Click here.

      • This torque value is effective when SST is parallel to the torque wrench.

    2. Connect the air fuel ratio sensor connector.

    3. Engage the 2 wire harness clamp.

  2. INSTALL AIR CLEANER AND HOSE


    1. A0118OFE01
      Text in Illustration
      *1 Clamp
      *2 Guide

      Align the 2 hinges with the guides on the case and engage them in the grooves.

    2. Install the air cleaner and hose with the 2 clamps.

    3. A0118N6E02
      Text in Illustration
      *1 Recession
      *2 Protrusion
      *a View A
      *b Upper Side

      Connect the air cleaner hose with the hose clamp as shown in the illustration.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

      Note


      • The clamp should contact the air cleaner hose stopper.


      • Perform the installation with the hose clip at the correct angle.

    4. Connect the ventilation hose.

    5. Install the mass air flow meter connector and the wire harness clamp.

  3. INSPECT FOR EXHAUST GAS LEAK