ACCELERATOR PEDAL ON-VEHICLE INSPECTION


  1. INSPECT ACCELERATOR PEDAL POSITION SENSOR


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the tester on.

    4. Enter the following menus: ECU Data Monitor / the No. 1 Accel sensor (VPA1) / the No. 2 Accel sensor (VPA2).

    5. Control the VVT System.

      Check the voltage while operating the accelerator pedal.

      Accelerator Position No. 1 Standard Voltage
      Condition Specified Condition
      Accelerator pedal is released 0.5 to 1.1 V
      Accelerator pedal is depressed 2.5 to 4.5 V
      Accelerator Position No. 2 Standard Voltage
      Condition Specified Condition
      Accelerator pedal is released 1.2 to 2.0 V
      Accelerator pedal is depressed 3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal, wire harness, and ECM.