THROTTLE BODY ON-VEHICLE INSPECTION


  1. INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY


    1. Turn the ignition switch to ON without operating the accelerator pedal.

      Note

      If the accelerator pedal is operated, perform the above steps again.

    2. Connect the intelligent tester to the DLC3 and clear the DTCs Click here.

    3. Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.

      Standard (for CVT)
      Condition Engine Idle Speed
      A/C switched off 600 to 700 rpm
      Standard (for Manual Transaxle)
      Condition Engine Idle Speed
      A/C switched off 550 to 650 rpm

      Tech Tips


      • Be sure to perform this step with all accessories off.

      • Make sure that the shift lever is in neutral.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Pos. Sensor Output. Fully depress the accelerator pedal and check that the value is 60% or more.

    5. Perform a road test and confirm that there are no abnormalities.