SFI SYSTEM, Diagnostic DTC:P0116

DTC Code DTC Name
P0116 Engine Coolant Temperature Circuit Range / Performance Problem

DESCRIPTION

Refer to DTC P0115 Click here.

DTC No. DTC Detection Condition Trouble Area
P0116

When either of following conditions met (2 trip detection logic):


  • During engine warming up after cold engine start, change in Engine Coolant Temperature (ECT) sensor output below threshold

  • In duration between warmed engine stopped and next cold engine start, change in ECT sensor output below threshold

  • Thermostat (built into inlet water with thermostat sub-assembly)

  • Engine coolant temperature sensor

INSPECTION PROCEDURE

Tech Tips


  • If any of DTCs P0115, P0117 or P0118 are set simultaneously with DTC P0116, the engine coolant temperature sensor may have an open or a short circuit. Troubleshoot those DTCs first.


  • Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

PROCEDURE


  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / DTC.

    5. Read the DTCs.

      Result
      Result Proceed to
      DTC P0116 is output A
      DTC P0116 and other DTCs are output B

      Tech Tips

      If any DTCs other than P0116 are output, troubleshoot those DTCs first.


    B

    GO TO DTC CHART Click here

    A

  2. INSPECT INLET WATER WITH THERMOSTAT SUB-ASSEMBLY


    1. Remove the inlet water with thermostat sub-assembly Click here.

    2. Inspect the inlet water with thermostat sub-assembly Click here.

    3. Reinstall the inlet water with thermostat sub-assembly Click here.


    NG

    REPLACE INLET WATER WITH THERMOSTAT SUB-ASSEMBLY Click here

    OK

    REPLACE ENGINE COOLANT TEMPERATURE SENSOR Click here