MANIFOLD ABSOLUTE PRESSURE SENSOR INSPECTION


  1. INSPECT DIESEL TURBO TURBO PRESSURE SENSOR

    A0119Q3E03
    Text in Illustration
    *1

    Component without harness connected

    (Diesel Turbo Turbo Pressure Sensor)

    1. Inspect the power source voltage.


      1. Disconnect the sensor connector.

        Turn the ignition switch to ON (IG).

      2. Measure the voltage according to the value(s) in the table below.

        Standard Voltage
        Tester Connection Switch Condition Specified Condition
        3 (VC) - 1 (E2) Ignition switch ON 4.5 to 5.5 V

      3. Turn the ignition switch to off).

      4. Connect the sensor connector.

    2. Check the vacuum and pressure.


      1. Connect the intelligent tester to the DLC3.

      2. Turn the ignition switch to ON and turn the intelligent tester on.

      3. Enter the following menus: Powertrain / Engine / Data List / Map and Atmosphere Pressure.

      4. Read the value.

        OK
        Condition Map and Atmosphere Pressure Value
        No pressure applied Same as atmospheric pressure
        Vacuum applied Becomes vacuum
        Pressure applied Becomes pressurized

        If the result is not as specified, replace the sensor.