ENGINE COOLANT TEMPERATURE SENSOR REMOVAL


  1. DRAIN ENGINE COOLANT

    CAUTION:

    To avoid the danger of being burned, do not remove the reserve tank cap sub-assembly while the engine and reserve tank assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.


    1. Loosen the radiator drain cock plug.

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

    2. Remove the reserve tank cap.

      A0116ZIE01
      Text in Illustration
      *1 Radiator Drain Cock Plug *3 Air Bleed Valve 1
      *2 Reserve Tank Cap Sub-assembly *4 Air Bleed Valve 2

  2. REMOVE WIPER MOTOR AND LINK


    1. Remove the wiper motor and link Click here.

  3. REMOVE BATTERY CLAMP SUB-ASSEMBLY


    1. A011ADE

      Remove the 2 nuts and the battery clamp.

  4. REMOVE BATTERY

  5. REMOVE BATTERY TRAY

  6. REMOVE FUEL FILTER SUPPORT WITH FUEL FILTER ASSEMBLY


    1. A011B6X

      Disconnect the 2 wire harness clamps.

    2. Disconnect the connector.

    3. A011A0C

      Disconnect the 2 connectors.

    4. A0119HL

      Disconnect the 2 fuel hose clamps from the fuel filter.

    5. Disconnect the 2 fuel hoses.

    6. A011BBN

      Loosen the fuel filter drain plug to drain fuel.

    7. Tighten the fuel filter drain plug.

    8. A0118XZ

      Remove the 2 nuts and fuel filter.

  7. REMOVE NO. 1 AIR TUBE


    1. A0119JX

      Loosen the 2 hose clamps.

    2. Disconnect the 2 air hoses.

    3. Remove the nut and the air tube.

  8. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. A011BKBE01
      Text in Illustration
      *1 19 mm deep socket wrench

      Disconnect the engine coolant temperature sensor connector.

    2. Using a 19 mm deep socket wrench, remove the engine coolant temperature sensor.