HEATED OXYGEN SENSOR INSTALLATION


  1. INSTALL NO. 2 OXYGEN SENSOR


    1. A011B18E01

      Using SST, install the oxygen sensor to the exhaust pipe assembly.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note


      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Click here.

      • This torque value is effective when SST is parallel to the torque wrench.

    2. Connect the wire harness clamp and oxygen sensor connector.

  2. INSTALL NO. 2 ENGINE UNDER COVER

    A011B72

    1. Install the engine under cover No. 2 with the 3 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }