ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

DRAIN ENGINE COOLANT (w/ Water Inlet Drain Cock Plug)

Text in Illustration

*1	Water Filler Cap Sub-assembly	*3	Radiator Drain Cock Plug
*2	Water Inlet Drain Cock Plug	-	-

CAUTION:

To avoid the danger of being burned, do not remove the water filler cap sub-assembly while the engine and assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.

1. Loosen the radiator drain cock plug.

   Tech Tips

   Collect the coolant in a container and dispose of it according to the regulations in your area.

2. Remove the water filler cap sub-assembly.

3. 

   Text in Illustration

   *1	Hose
   *2	Water Inlet Clip

   Connect the hose to the water inlet drain cock plug.

4. Remove the water inlet clip.

5. 

   Pull out the water inlet drain cock plug.

DRAIN ENGINE COOLANT (w/o Water Inlet Drain Cock Plug)

1. Tighten the radiator drain cock plug.

2. Remove the water filler cap sub-assembly.

3. Slowly fill the radiator with TOYOTA Super Long Life Coolant (SLLC).

   Standard Capacity
   Item Capacity for Manual Transaxle 4.3 liters (4.5 US qts, 3.8 Imp. qts) for CVT 4.5 liters (4.8 US qts, 4.0 Imp. qts)

   Note

   Never use water as a substitute for engine coolant.

   Tech Tips

   TOYOTA vehicles are filled with TOYOTA SLLC at the factory. In order to avoid damage to the engine cooling system and other technical problems, only use TOYOTA SLLC or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, non-borate coolant with long-life hybrid organic acid technology (coolant with long-life hybrid organic acid technology is a combination of low phosphates and organic acids).

4. Squeeze the inlet and outlet radiator hoses several times by hand, and then check the level of the coolant.

   If the coolant level is low, add coolant.

5. 

   Text in Illustration

   *a

   FULL Line

   Fill the radiator reserve tank with coolant to the FULL level.

6. Install the water filler cap sub-assembly.

7. Start the engine and warm it up.

8. Bleed air from the cooling system.

   Note

   
   

   • Before starting the engine, turn the A/C switch off.

   • Adjust the air conditioning temperature setting to MAX (HOT).

   • Adjust the air conditioning blower setting to LO.

   
   

   1. Warm up the engine until the thermostat opens. While the thermostat is open, allow the coolant to circulate for several minutes.

      Tech Tips

      Thermostat opening timing can be determined by squeezing the inlet radiator hose, and sensing vibrations when the engine coolant starts to flow inside the hose.

      CAUTION:

      When squeezing the radiator hoses:
      

      • Wear protective gloves.

      • Be careful as the radiator hoses are hot.

      • Keep your hands away from the radiator fan.

9. Stop the engine, and wait until the engine coolant cools down.

10. Remove the water filler cap sub-assembly and check the coolant level.

    If the coolant level is below the LOW line, repeat all of the procedures above.

11. 

    Text in Illustration

    *a	FULL Line
    *b	LOW Line

    When the coolant level stops going down, check that the coolant level is between the FULL and LOW lines.

    If the coolant level is low, add coolant to the reservoir tank FULL line.