OUTER REAR VIEW MIRROR DISASSEMBLY

REMOVE OUTER MIRROR GLASS

Text in Illustration
*1	Protective Tape
*2	Moulding Remover

Apply protective tape to the bottom of the visor of the door mirror.

Push the upper part of the mirror surface and tilt it.
Using a moulding remover, disengage the 2 claws and 2 guides and remove the outer mirror glass.

REMOVE OUTER MIRROR COVER
1. Disengage the 4 claws from the upper inside of the mirror body.
2. Push the upper part of the mirror cover forward to tilt it, and then disengage the 3 claws on the lower part to remove the outer mirror cover.
REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY
1. Disconnect the connector.
2. Remove the 3 screws and remove the side turn signal light.
REMOVE OUTER MIRROR RETRACTOR
1. Text in Illustration
  
  *1 Vinyl tape
  
  Remove the vinyl tape.
2. Text in Illustration
  
  *a Cut
  
  Cut the wire harness at the position shown in the illustration.
  
  Note
  
  Make sure to replace the wire harness with a new one.
3. Disengage the 5 pins and remove the gasket.
4. Using a screwdriver, disengage the 2 claws.
5. Disengage the 3 claws and remove the lower cover as shown in the illustration.
6. Disengage the clamp.
7. Using a T25 "TORX" socket wrench, remove the 3 screws and base.
  
  Note
  
  Make sure to replace the "TORX" screws with new ones.
8. Remove the 3 screws.
9. Slide the guide in the direction indicated by the arrow in the illustration and remove the frame sub-assembly.
10. Text in Illustration
  
  *1 Cap
  
  Remove the cap and disconnect the connector.
11. Remove the 2 screws and mirror actuator.
12. Disengage the clamp.
13. Disconnect the 2 connectors.