BACK DOOR REASSEMBLY


  1. INSTALL BACK DOOR WEIGHT (w/ Weight)


    1. A011BM5

      Install the back door weight and guide with the 3 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  2. INSTALL HIGH MOUNTED STOP LIGHT ASSEMBLY

    A011982

    1. Install the high mounted stop light with the 2 clips.

    2. Connect the connector.

  3. INSTALL BACK DOOR OUTSIDE HANDLE


    1. A011968

      Install the back door outside handle with the bolt.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }
    2. A011BLD

      Connect the connector.

    3. Engage the 2 clamps.

  4. INSTALL BACK DOOR LOCK ASSEMBLY


    1. A011ASG

      Install the back door lock assembly with the 3 bolts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

    2. Connect the connector.

  5. INSTALL DOOR PULL HANDLE


    1. A0119O5

      Engage the 4 claws and install the door pull handle.

  6. INSTALL REAR WIPER MOTOR GROMMET


    1. A011AM3E03
      Text in Illustration
      *1 MP grease

      Apply MP grease to the entire surface of the wiper motor grommet lip.

      Tech Tips

      Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.

    2. A01196VE01
      Text in Illustration
      *1 Upper Mark

      Install the rear wiper motor grommet with the mark directed up.

  7. INSTALL REAR WIPER MOTOR ASSEMBLY


    1. A011B5T

      Install the rear wiper motor with the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Connect the connector.

  8. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY


    1. A0119YTE03
      Text in Illustration
      *1 Wiper Arm Serration
      *2 Wiper Pivot Serration
      *3 Wire Brush

      Clean any metal powder off the serrated part of the wiper arm with a round wire brush or the equivalent (when reinstalling).

    2. Clean the wiper pivot serrations with a wire brush.

    3. Operate the wiper, and then stop the rear wiper motor in the automatic stop position.

    4. A01199FE01
      Text in Illustration
      *1 Mark for Blade Position

      Install the rear wiper arm into the position shown in the illustration with the nut.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Tech Tips

      Hold the arm hinge down by hand while tightening the nut.

    5. A0117KL

      Close the rear wiper arm head cap.

  9. INSTALL BACK DOOR TRIM BOARD


    1. A011735

      Engage the 9 clips and install the back door trim board.